Reviewer:
jacob peterson
from duluth, MN United States
Simple to install and if you have the UMP shroud its a must. Otherwise you'll have a hole on top of your shroud. I had no problems with the screws as the previous guy had mentioned.
Was this review helpful to you?
0 of 0 people found the following review helpful:
very good
October 23, 2007
Reviewer:
Christiaan Boot
from Netherlands
very good, Its a simple build looks great and its durable. Only it has one problem. The screws that came with it ain't the same tread as the tread on the new G36 shroud's. Thai are a size to thin so you cant tighten them. I joust the screws on my old G36 shroud. And thy are of the same size. a bit to long but not long inuf to damage the under half of the shroud.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Great For Show
September 1, 2007
Reviewer:
Flatlinerz
from AZ
This is a great piece to add to the realism of a milsim marker's looks but it's not really functional as is. As stated it sits too low to line up with the front sight, however with a little ingenuity and minor shop skills this can be remedied and makes a decent ghost ring backup iron sight when not using an optic on your marker.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Looks cool
May 18, 2007
Reviewer:
Byrd2000
from Newport Beach, CA United States
Looks cool, but it's hard to see through with a mask on.
Was this review helpful to you?
0 of 0 people found the following review helpful:
ok
May 18, 2007
Reviewer:
Aaron Healy
from Cape Coral, FL United States
It definatly finishes ofrf the look of the UMP but it doesn't line up with the front sight at all. It would be nice if it was adjustable in some way.Good quality product but again doesn't line up at all. Also it is down right inpossible to see through with make on unless you have a folding stock.
Rear Sight 
very good 
Great For Show 
